It won't start!

[tonalt]

I have dbox2 Nokia with Neutrino 1.8.1. I flashed new image with this method: http://www.yadi.org/anleitungen/install ... no_install

Image is http://www.yadi.org/disclaimer.php?file ... ead_2x.img

It flashed ok, then it said something like "press ok for reboot". I pressed ok, and then it shutted down. Then I turned it on. It loads boot-logo and then it says on LCD-screen "loading kernel". Now it just hangs and won't start!

Is there anything to be or is it dead??

[rasc]

Maybe something went wrong during flashing.
Just reflash and take care of your ucodes...

[GlennGould]

Maybe something went wrong during flashing.
Just reflash and take care of your ucodes...

Hy,

i've the same problem, that the d-box isn't starting....only the yadi-screen appears on TV and on LCD-screen - booting....loading kernel.
I can't do anything...it is rebooting after a few minutes....

How should i refalsh the d-box? via ftp (IP-adress)? no ping possible...

I hope you can help me...

kind regards

Roland

PS: You can reply in german as well - i'm from Austria!

[move]

could you please post the serial log? maybe we can then figure out what's wrong...

move

[GlennGould]

could you please post the serial log? maybe we can then figure out what's wrong...

move

How should i get the serial-log?
I haven't this before, but it is not possible to get any response from my d-box....if i try ping / telnet / ftp it with the ip befor it happens. (like 192.168.6.10)

many thanks
GlennGould

[rasc]

to get a boot log (serial log) from the dbox2, do the following:

- connect dbox2 to PC using a serial crossed cable (NULL-Modem)

- use dbox2bootmanager to review the bootlog (use cut&paste to post it here).


For flashing the dbox2 you should use the dbox2bootmanager.

[GlennGould]

to get a boot log (serial log) from the dbox2, do the following:

- connect dbox2 to PC using a serial crossed cable (NULL-Modem)

- use dbox2bootmanager to review the bootlog (use cut&paste to post it here).


For flashing the dbox2 you should use the dbox2bootmanager.

I've read it allready at an other topic.....with the bootmanager!
The problem with the connection between PC and d-box is still active.
-connect them via ethernet with the old ip -> error: Pinging Dbox...failed!
-flash it with bootmanager -> error: access denied!

[DieMade]

"access denied!" - the image is likely read-only (i.E. copied from a CD), the Bootmanager needs to open it read/write.

[GlennGould]

What's the way to change the properties....like read only or write?
-> That it would be possible to flash it!

Many thanks

[rasc]

Standard Windows file properties...

del-select read_only or select write permissions (depends on your Win-OS)

[GlennGould]

I've checked de image-file, i've downloaded from the internet....but there is everthing ok!
I think the message "Acceess denied" (from the bootmanager) correlates to the d-box - the permission to change something on it - like flashing!